Техника для добычи нефти и газа |
звонки по РФ бесплатно
8 800 555-41-71
|
|||
AKN-16 |
|
цена по запросу |
AKN-16 M |
|
цена по запросу |
AKN-16 OD |
|
цена по запросу |
AKN-16 ODM |
|
цена по запросу |
AKN-16 |
|
цена по запросу |
AKN-16 М |
|
цена по запросу |
AKN-16 OD |
|
цена по запросу |
AKN-16 ODM |
|
цена по запросу |
AKN-16 |
|
цена по запросу |
AKN-16 М |
|
цена по запросу |
AKN-16 ОД |
|
цена по запросу |
AKN-16 ODM |
|
цена по запросу |
AKN-16 |
|
цена по запросу |
AKN-16 M |
|
цена по запросу |
AKN-16 OD |
|
цена по запросу |
AKN-16 ODM |
|
цена по запросу |
Capacity, cubic meter | 16 |
---|---|
Cross-section form | circle |
The number of sections | 1 |
Bottom opening | mechanical/not (depends on configuration) |
Steel grade | 09G2S (09Г2С) (low-allow steel with a minimum thickness of 4 mm) |
Side framing | eternal frame |
Tanker and chassis fixation | Belt fixation (“fixed type”) or Technological support (“main support”) |
Characteristic | КО-505 | PNR-122 | PVT-200 | PVT-400 | ВК-6М2 | ВР-8/3 |
---|---|---|---|---|---|---|
Delivery volume, m3/h | 310 | 740 | 1200 | 1500 | 240 | 480 |
Continuous work time, h | 1 | |||||
Pump efficiency, % | 80–90 | 92 | 92 | 92 | ||
Rotating speed, rpm | 1150 | 1300 | 3000–4500 | 3000–4500 | 1500 | 26 |
Self-suction lift, m | 4 | |||||
Peak underpressure | 0,085 MPa | 92% | 0,0037 MPa | 0,0037 MPa | 0,0039 MPa | |
Peak pressure, bar | 0,6 | 2 | 2 | 2 | 1,5 | 2,93 |
Pump power, kW | 9 | 19 | 38 | 38 | 22 | 22 |
Peak heating, °С | 80 | 150 | 90 | 90 | – | – |
Mass, kg | 125 | 177 | 160 | 240 | 530 | 170 |
Pump drive | PTO-driven / additional engine dependent PTO / hydraulical drive / drive shaft |
---|---|
Delivery-suction hoses | 2 pcs., DN 75 mm, length 6 meters |
Cases for hoses packaging | Metal cases at both sides of tanker; length 4 m; width 0,48 m |
Vacuum unit protecting components |
The first shutdown valve in a filler pipe, the second shutdown valve in a receiver, vacuum valve (-0,8 kg/cm2), pressure relief valve (0,4 kg/cm2), max level sensor MS DUG11-N-10 with chassis engine cut-off. |
Model | |
---|---|
Auxiliary equipment | Power take off (PTO), Towing hitch (depending on specification) |
Brakers | |
Brake lining width, mm | 140 |
Dimensions: drum Ø, mm | 400 |
Drive | pneumatic |
Cab | |
Configuration | day-cab |
Type | high or low roof, over the engine (depends on truck configuration) |
Characteristic of gvw vehicle | |
Climbing angle, no less, % | 18 (10°) |
Maximum speed, no less, km/h | 80 |
Outer turning radius between walls, m. | 11,3 |
Clutch | |
Actuation | hydraulic, with pneumatic booster |
Type | diaphragm, single-disk, mod. ZF&SACHS MF 430 |
Electrical equipment | |
Batteries, V/A hour | 2х12/190 |
Generator, V/W | 28/3000 |
Voltage, V | 24 |
Engine | |
Cylinder arrangement and number | V-shaped, 8 |
Cylinder Ø and piston stroke, mm | 120/130 |
Degree of compression | 17,9 |
Engine displacement, L | 11,76 |
Fuel feed system | Common Rail |
Maximum net horsepower, kW (h. p.) | 206 (280) |
at crankshaft rotation speed, rpm | 1900 |
Maximum net torque, Nm (kgfm) | 1177 (120) |
at crankshaft rotation speed, rpm | 1300 |
Model | 740.662-280 |
Type | turbocharged diesel, with aftercooling |
Final drive | |
Ratio | 4,98 or 5,43 (depending on specification) |
Transfer case | |
Control | pneumatic |
Type | mechanical, two-speed with interlocking differential |
Fuel system | |
Fuel tank capacity, L | 210 or 210+210 or 210+350 (depending on specification) |
Transmission | |
Control | mechanical, remote control |
Gear ratios | мод. ZF 9S1310: 1-9,48; 2-6,58; 3-4,68; 4-3,48; 5-2,62; 6-1,89; 7-1,35; 8-1,00; 9-0,75; ЗХ-8,97 мод. KАМАZ-154: 1-7,82-6,38; 2-4,03-3,29; 3-2,50-2,04; 4-1,53-1,25; 5-1,000-0,815; ЗХ-7,38-6,02 |
Number of gears | 9 |
Weight characteristics and loads | |
Chassis curb weight, kg | 8625/*8275/**8925 (depending on specification) |
Front axle load, kg | 4475/*4275/**4565 |
Rear axle load, kg | 4150/*4000/**4360 |
Gross combination weight, kg | 38200 |
Gross trailer weight, kg | 13000 |
Gross vehicle weight, kg | 25200 |
Rear trailer bogie load, kg | 19000 |
Front axle load, kg | 6200 |
Permissible mass of superstructure with load, kg | 16575/*16925/**16275 (depending on specification) |
Wheels and tyres | |
Rim size | 7,5-20 or 8,25-22,5 (7,5-22,5) (depending on specification) |
Tyre size | 11.00 R20 or 11.00 R22,5 (depending on specification) |
Tyre type | pneumatic, tube or tubeless-type (depends on truck configuration) |
Wheel type | disk wheels |
Vacuum truck (AKN-16) based on KAMAZ-65111 chassis is used for oil and petroleum gathering, gas-condensate, non-aggressive process liquids gathering, and their transportation for recycling.
Tankers AKN-16 may be performed for all climate zones, a sleeping berth is optional.
Tanker AKN-16 is a cistern installed on “KAMAZ” chassis.
Cistern – is a welded construction of two bottoms and drum shell.
An operating platform with a non-slip perforated flooring is available on the tanker. A ladder is also pre- installed for comfortable lifting.
In the foot of the back bottom there is a flanged pipe with a filler flap. On a flap there is a butterfly valve, which makes the pipe opened or closed when turning. All connections are tight due to hermetical seals. The hose is attached to the filler flap with a coupling nut. The hose includes a delivery-suction hose DN 100mm, a coupling nut for connection with a filler, and a gasket.
Compressor is designed for creating vacuum during the filling and creating pressure during the discharge. A vacuum truck unit includes: vacuum pump, grease filter, moisture separator, pipe system with ball valves.
The pump drives from the chassis engine through the drive shaft.
The tanker is installed on a frame mounted support which combines with chassis. The supports are attached to a metal cradle structure which is fixed on a mainframe with U-bolts. Under the supports in cradles there are metal ribs which protect from crushing. Under a frame support there are ribbon springs.
Electrical wiring is layed through metal hoses, all connections are encapsulated, equipment is performed in explosion-proof configuration.
The tanker is provided with a warning sign “Flammable”. On a back side there is a ground circuit. 200 mm of it must contact the road surface.
ООО «НПО «ВЕКТОР»
г. Миасс, Тургоякское шоссе, 5-9а, офис 340 |
8 800 555-41-71 | info@vektornpo.ru |