Manifold unit is intended for connecting pump units with wellhead during cementing of wells, hydraulic fracturing of formations and performing of other flushing and squeezing operations.
Manifold units BM-70/32 KAMAZ-43118
| Manifold unit: | BM-70/32 |
| Chassis: | KAMAZ-43118 (6×6, 280/300 hp, E-4) |
| Composition: | shelter, SKCS, hoisting device, attached implements |
| Capacity: | 500 kilo |
| Chassis: | KAMAZ-43118-3018(19)-46 |
| Engine | 750.662.300 |
| Transmission | ZF 9S1310 |
| Wheel arrangement | 6×6 |
| Wheelbase, mm | 4100+1320 |
| Manifold unit | |
| Maximum operating pressure: | |
| - in pressure manifold, MPa (kgf/cm2) | 70 (700) |
| - in supply manifold, MPa (kgf/cm2)2) | 2,5 (25) |
| Number of branch pipes, pcs.: | |
| - in pressure manifold | 6 |
| - in supply manifold | 8 |
| - from pressure manifold to production wellhead | 2 |
| Nominal inside diameter of branch pipe, mm | 50 |
| Well-cementing control station (SKCS) | |
| Measured parameters, measurement limits: | |
| - density, kg/m3 | 800...2000 |
| - consumption, m3/min | -0...3,0 |
| - pressure, MPa (kgf/cm2) | 0...40 (400) (при рабочем давлении до 32 МПа) |
| - temperature, 0C | 50...+100 |
| Hoisting device: | |
| - lifting capacity, kg | 500 |
| - boom extension, mm | 1600 |
| - height of lift, mm | 2860 |
| Dimensions, mm, max | |
| - length | 9350 |
| - width | 2500 |
| - height | 3600 |
| Fully loaded mass, kg | 13600 |
| Configuration | |
| Chassis, pc. | 1 |
| Shelter, pc. | 1 |
| Attached implements: | |
| - pressure manifold, pcs. | 1 |
| - pressure-relief valve, pcs. | 1 |
| - separator with shock absorber, pcs. | 1 |
| - supply manifold, pcs. | 2 |
| - secondary piping, pcs.: | |
| Pipe L=4000 mm | 6 |
| Pipe L=2000 mm | 6 |
| - discharge hose 2”, pcs. | 1 |
| - swivel joint, pcs. | 16 |
| - fork arms, pcs. | 4 |
| - adapter, pcs. | 4 |
| Well-cementing control station (SKCS) | 1 |
| Hoisting device, pcs. | 1 |
| Spare parts and tools set | 1 |
KAMAZ-43118 chassis specification
| Model | |
|---|---|
| Auxiliary equipment | Towing hitch, Power take off (PTO), Winch (depending on specification) |
| Brakers | |
| Brake lining width, mm | 140 |
| Dimensions: drum Ø, mm | 400 |
| Drive | pneumatic |
| Cab | |
| Configuration | day-cab or sleeper cab (depends on truck configuration) |
| Type | high or low roof, over the engine (depends on truck configuration) |
| Characteristic of gvw vehicle | |
| Climbing angle, no less, % | 31 |
| Maximum speed, no less, km/h | 90 |
| Outer turning radius between walls, m. | 11,5–12,9 |
| Clutch | |
| Actuation | hydraulic, with pneumatic booster |
| Type | diaphragm, single-disk, mod. ZF&SACHS MF 430 |
| Electrical equipment | |
| Batteries, V/A hour | 2х12/190 |
| Generator, V/W | 28/3000 |
| Voltage, V | 24 |
| Engine | |
| Cylinder arrangement and number | V-shaped, 8 |
| Cylinder Ø and piston stroke, mm | 120/130 |
| Degree of compression | 17 |
| Engine displacement, L | 11,76 |
| Fuel feed system | Common Rail |
| Maximum net horsepower, kW (h. p.) | 221 (300) |
| at crankshaft rotation speed, rpm | 1900 |
| Maximum net torque, Nm (kgfm) | 1275 (130) |
| at crankshaft rotation speed, rpm | 1300 |
| Model | 740.662-300 |
| Type | turbocharged diesel, with aftercooling |
| Final drive | |
| Ratio | 5,94 |
| Transfer case | |
| Control | pneumatic |
| Type | mechanical, two-speed with interlocking differential |
| Fuel system | |
| Fuel tank capacity, L | 210 or 350 or 210+210 or 350+210 (depending on specification) |
| Transmission | |
| Control | mechanical, remote control |
| Gear ratios | 1-9,48; 2-6,58; 3-4,68; 4-3,48; 5-2,62; 6-1,89; 7-1,35; 8-1,00; 9-0,75; ЗХ-8,97 |
| Model | ZF 9S1310 |
| Number of gears | 9 |
| Weight characteristics and loads | |
| Chassis curb weight, kg | 8845...9395 (depending on specification) |
| Front axle load, kg | 4785…5275 (depending on specification) |
| Rear axle load, kg | 3810…4300 |
| Gross combination weight, kg | 33600 |
| Gross trailer weight, kg | 12000 |
| Gross vehicle with superstructure weight, kg | 21600 |
| Rear trailer bogie load, kg | 15800 |
| Front axle load, kg | 5800 |
| Permissible mass of superstructure with load, kg | 12680...12130 (depending on specification) |
| Wheels and tyres | |
| Rim size | 10.00-20 or 12.2-20,9 (depending on specification) |
| Tyre size | 390/95 R20 or 425/85 R21 (depending on specification) |
| Tyre type | pneumatic, with pressure control |
| Wheel type | disk wheels |
Our partners
Trust us
It is beneficial to cooperate with us!
Flexible system of discounts and payment terms
Delivery across Russia in any way, the delivery to the CIS countries and Africa
Formed warehouse for constant demand parts
Free field service team on the warranty period
Loyalty of all leasing companies in the Russian Federation
Improvement and any revision of specialized equipment
Own technical control service
Extended service life of tanks - 5 years
Video review
Contacts
+7 919 111-41-95
Sh.Turgoyakskoe, 13, Room 340, Miass, Chelyabinsk region, Russian Federation
© NPO «VEKTOR», 2024 г. Copying of site materials is prohibited
Website creation: 
Алгоритм Успеха
Алгоритм Успеха